Multi Axis Stand - EVB021 – VE Help Centre

Multi Axis Stand - EVB021

Remove the multi-axis stand column, base and accessories from the box.
Carefully release the clamp ❶ to allow the column to extend.
Ensure you have plenty of space as the stand will increase in length once the clamp is released.

Remove the label ❷.
Remove the bolt ❸ using the 5mm allen key provided.
Unscrew the transit bung ❹ from the base of the column.
The transit bung has a threaded hole and the pole at the base of the column is threaded.

Using the circular metal clamp plate ❶ as a template to decide the position on the workbench where the multi-axis stand is to be located.
Mark the location of the holes to be drilled.
Drill holes 13mm diameter through the workbench.
Place washer ❷ and then nut ❸ onto the end of the threaded pole ❹ at the bottom of the base.
Place the nut through the center hole and align the mounting holes with the holes drilled in the workbench and hold in place.
Using the threaded studs ❺ provided and washers ❻ and nuts ❼ fix the multi axis stand in position so that the clamp plate is positioned beneath the workbench.

For details of how the stand adjusts follow here.

Note: This stand is compatible with a range of our products.

While your main unit may look different, the operation is exactly the same.

For base fitting follow here.

For base fitting follow here.

For focus block fitting follow here.

For extension pole fitting follow here.

For monitor mount fitting follow here.

For mini monitor mount fitting follow here.